Filter
Top Products
SETUP
Tools required: Socket set, Phillips Screwdriver, 9/16" open end wrench
Please read instructions carefully before assembly. Be sure to assemble the unit where it is to be used.
STEP 1
Remove the machine from packaging. Carefully lay out and count each part before assembly. Refer to the parts list on
page 9 of this manual.
STEP 2
Assemble the upright tube assembly to the base frame:
NOTE: This step could require two people.
1. Position the upright tube assembly (A) between the plates on the
front of the base frame (B).
2. Line up the holes on the plates (B) with the holes on the upright
tube assembly (A).
3. Connect the upright tube assembly (A) to the base frame (B) using
four (#5) 3-1/4" bolts, eight (#7) washers (4 on each side) and four
(#6) high profile nylock nuts. DO NOT FULLY TIGHTEN AT THIS
POINT.
CAUTION: The wire harness may obstruct the connecting holes. If this
happens, gently pull on the end of the wire harness at the top of the
upright tube assembly (A) to clear the hole. Do not force the bolt
through the hole if the wire harness is obstructing the bolt, as
damage to the wire harness may result.
10