Filter
Top Products
12
3.7 ACCESSORY TRAYS & CONSOLE
Parts: Hardware Bag #5 (2, 8mm Phillips Screws)
(4, 12mm Self-Tapping Screws)
Tools: Phillips Screwdriver
C3 Only: Locate the ACCESSORY TRAY (V). Position the ACCES-
SORY TRAY near the top of the MONOCOLUMN (E) at the DIS-
PLAY CONSOLE BRACKET (W).While holding the CONSOLE
WIRE (X) and HEART RATE WIRE (Y), cut the wire tie securing
the CONSOLE WIRES to the DISPLAY CONSOLE BRACKET.
Feed the CONSOLE WIRES through the center hole of the
ACCESSORY TRAY MOUNTING BRACKET (Z). Secure the
ACCESSORY TRAY to the DISPLAY CONSOLE BRACKET using
two 8mm PHILLIPS SCREWS (13). Tighten the SCREWS securely.
CAUTION: Be careful not to pinch the CONSOLE WIRE (X) and
HEART RATE WIRE (Y) when securing the ACCESSORY TRAY
(V) to the DISPLAY CONSOLE BRACKET (W).
Note: Be careful not to let the CONSOLE WIRE (X) and HEART
RATE WIRE (Y) fall into the DISPLAY CONSOLE BRACKET (W).
Remove the DISPLAY CONSOLE (AA) from its shipping carton. Position the DISPLAY CONSOLE above the ACCESSO-
RY TRAY (V). Connect the CONSOLE WIRE 15-pin connector (X), HEART RATE WIRE 4-pin connector (Y), SUPPLE-
MENTAL POWER WIRE 2-pin connector (MM), and GROUND WIRE single spade (BB) (Green) to the corresponding
CONNECTORS located on the back of the DISPLAY CONSOLE. Secure the DISPLAY CONSOLE to the DISPLAY
CONSOLE BRACKET (W) using four 12mm SELF TAPPING SCREWS (17). Tighten the SCREWS securely. Do not
overtighten the SCREWS.
C1 Only: Remove the DISPLAY CONSOLE (AA) from its shipping carton. While holding the CONSOLE WIRE (X) and
HEART RATE WIRE (Y), cut the wire tie securing the CONSOLE WIRE to the DISPLAY CONSOLE BRACKET (W).
Position the DISPLAY CONSOLE above the DISPLAY CONSOLE BRACKET. Connect the CONSOLE WIRE 15-pin con-
nector (X), HEART RATE WIRE 4-pin connector (Y), and GROUND WIRE single spade (BB) (Green) to the correspon-
ding CONNECTORS located on the back of the DISPLAY CONSOLE. Secure the DISPLAY CONSOLE to the DISPLAY
CONSOLE BRACKET using four 12mm SELF TAPPING SCREWS (17). Tighten the SCREWS securely. Do not over-
tighten the SCREWS.
Note: Be careful not to let the CONSOLE WIRE (X) and HEART RATE WIRE (Y) fall into the DISPLAY CONSOLE
BRACKET (W).
X
Y
BB
MM
MM
Go Console Connections
Y
X
BB
MM
Track Console Connections