BLOCK
PULLEY
BOLT
FIGURE 8
FIENCH FRAME
STEP 8:
A. Remove the BOLT, WASHERS, and LOCK NUT below the PULLEY in UPRIGHT. See FIGURE 8.
B. Insert the threaded end of CABLE (part #6671001) under the PULLEY in UPRIGHT and around the
bottom PULLEY of the PULLEY BLOCK. See FIGURE 8.
C. Fasten end of CABLE (part #6671001) into threaded housing on the base of BENCH FRAME and
tighten jam nut securely.
D.
Securely fasten previously removed BOLT, WASHERS, and LOCK NUT. (NOTE: The CABLE
(part #667100 l) should be routed over the bolt and washer.
7