Filter
Top Products
STEP 3:
A. Insert the two GUIDE RODS (2) into the base
the TOWER as shown in FIGURE 3. Lubricate the
GUIDE RODS with a slicon or teflon spray that is
available at most hardware stores.
B.
Slide two WEIGHT STACK CUSHIONS (6) down
over the GUIDE RODS (2). See FIGURE
C. Using EXTREME CARE slide twenty WEIGHT
PLATES (5) down over the GUIDE RODS (2)
the "PARABODY" side up and the key-hole fac-
ing as shown in FIGU-RF, 3.
Do
Securely assemble the WEIGHT STACK SHAFT
(1) to the HEAD PLATE (3) using one 3/8
BUTTON HEAD C.AP SCREW (9) and one 3/8"
LOCK WASHER (10). (Note: The bolt hole
the HEAD PLATE (3) should be on top.)
Carefully Slide the HEAD PLATE ASSEMBLY
(1 & 3) down over the GUIDE RODS (2) onto
weight stack as shown in FIGURE 3.
FIGURE 3
rOWER
3/8" X 1"
TOWER
BRACE
]FIGURE 4
STEP 4:
Insert two GUIDE ROD BUSHINGS (8) into the holes in the TOWER BRACE. See FIGURE