Filter
Top Products
Problem
Cause / Solution
When I try to save a workout on the
USB stick I receive the following
message: UNABLE TO SAVE SEE
MANUAL.
Note: Applies to Track Console only.
The console may not have recognized the USB stick. Try unplugging the
USB stick and plugging it back in.
The USB stick may be full.
The USB stick may not be compatible with the product.
Try using a different USB stick.
The wireless heart rate is not
working.
Potential reasons for the wireless heart rate not to work properly include:
1. The wireless heart rate is turned OFF in the Settings Menu. Enter the
Settings Menu and verify that WIRELESS HR is turned ON.
2. There is poor contact between the telemetry heart rate strap and the
skin. Refer to Heart Rate Telemetry Strap for details.
3. There is electrical interference from electrical appliances with the
telemetry heart rate strap from fluorescent lights, kitchen appliances,
etc. Move the treadmill to a different location or move electrical
appliances away from the treadmill.
4. The battery in the Heart Rate Telemetry Strap needs to be replaced.
The battery is a CR2032 (3V).
A heart rate reading is initially
detected and functioning normally
but then is lost.
Use of personal electronic devices, such as cell phones and portable
mp3 players, causes external noise interference.
Equipment is in close proximity to other sources of noise such as audio/
video equipment, fans, two way radios, and high voltage/high current
power line
Remove the source of noise or reposition the exercise equipment.
“OFF” is displayed in the incline window.
This message relates to a problem with the Incline system.
If the incline has been repeatedly moved up and down in a manual
program, the lift motor may have activated a thermal protection device.
Simply let the treadmill sit for 30 minutes and cycle power.
Recalibrate the treadmill following the instructions in Section 3.6
Calibration.
“Immobilized” is displayed in window.
The treadmill has been immobilized through software. Press the
SPEED DOWN ARROW and STOP on the Activity Zone to exit this state.
iPod is not recognized.
Note: Applies to Track Console only.
This is displayed if your version of the iPod Player is not supported by
the treadmill.
It may also be displayed if the connector on the treadmill or iPod
is damaged.
iPod is not charging while in Energy
Saver mode.
Note: Applies to Track Console only.
Your iPod will not charge if the treadmill enters Energy Saver mode. This
is normal.
”Low Battery” message is displayed
on the console.
Note: Applies to Track Console only.
The console has an internal battery that keeps the real time clock
functioning if the treadmill is unplugged. This real time clock is only
needed if you use the Life Fitness ”Virtual Trainer” website. You do
not need to replace the battery if you do not use the website. Contact
Customer Service for guidance on how to change the battery. The
battery is a CR1632 (3V).
18