Filter
Top Products
7
FIGURE 8
STEP 8:
• Insert two GUIDE RODS (4) into the STACK
BASE (1) as shown in FIGURE 8. Lubricate the
GUIDE RODS (4) with a slicon or teflon spray
that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (21)
down over the GUIDE RODS (4). See FIGURE 8.
• Using EXTREME CARE slide twenty WEIGHT
PLATES (25) down over the GUIDE RODS (4)
with the key-hole facing as shown in FIGURE 8.
• Securely assemble the 20 HOLE SELECTOR
SHAFT (5) to the HEAD PLATE (24) using one
3/8 X 1-1/4” BOLT (12) and one 3/8” WASHER
(15). (Note: The bolt hole in the HEAD PLATE
(24) should be on top.)
• Carefully Slide the HEAD PLATE ASSEMBLY
(5 & 24) down over the GUIDE RODS (4) onto
the weight stack as shown in FIGURE 8.
• Apply one set of WEIGHT STACK LABELS -
1-25 (26) to each WEIGHT PLATE (25) as shown
in FIGURE 8.
• Slide two 13/16” SHAFT COLLARS (9) over
the GUIDE RODS (4) as shown in FIGURE 8.
4
3/8 X 1-1/4” 12
24
15
5
25
21
1
26
9