Filter
Top Products
STEP 5:
FIGURE 5
7
STEP 6:
FIGURE 6
• SECURELY assemble SEAT PAD (15) to HINGE TABS (45) using two 3/8 X 1-1/4” BOLTS (38) and two 3/8” WASHERS (41).
See FIGURE 5.
• SECURELY assemble one 1/2 X 7-7/8” SPRING PIN (46) to the BENCH FRAME (7) as shown in FIGURE 5. (NOTE: IMPORTANT!
Tighten SPRING PIN completely.)
• Assemble RIGHT (12) & LEFT (13) PAD
SUPPORTS to the BENCH FRAME (7) using one
1/2 X 6-1/2” BOLT (32), two 1/2” FLANGE
BEARINGS (50), and one 1/2” LOCK NUT (43)
as shown in FIGURE 6. (NOTE: Securely tighten,
then back nut off 1/4 turn to allow the two parts
to rotate freely.)
15
46
7
3/8 X 1-1/4” 38
41
45
50
1/2 X 6-1/2” 32
7
43
13
12