Filter
Top Products
12
STEP 12:
FIGURE 11
FIGURE 12
• Slide one BEARING HOUSING (1), one 2” SHAFT COLLAR (23), and one 2-1/2” OD RUBBER BUMPER (29) over each
SLEEVE ASSEMBLY (4) as shown in FIGURE 11.
• Using a 1/4” Allen wrench, SECURELY tighten each set screw on the 2” SHAFT COLLARS (23). See FIGURE 11.
• Slide one BEARING HOUSING (1) & SLEEVE ASSEMBLY (4) over each end of the SMITH BAR (7) as shown in FIGURE
12.
DETAIL 12
STEP 11:
• Using a 5/16” Allen wrench, SECURELY tighten the SLEEVE ASSEMBLIES (4) to the SMITH BAR (7) with two 5/8 X 1-1/
4” SHOULDER BOLTS (19). See DETAIL 12.
29
23
4
1
23
1
4
29
5/8 X 1-1/4” 19
1
7
4
1
1
7
4
19
19
4
0
1
2
3 4 5
6
1/2 1/2 1/2 1/2 1/2 1/2
LEFT RIGHT