Filter
Top Products
701
FACTOR 525 PEC DEC ATT. ASSEMBLY INSTRUCTIONS (LEVEL 2)
The D-lUNG CABLE CLIP on the end of the LINK CABLE shouid restljust above the D-RING. If the
LINK CABLE seems to be pulling on the D-RING or is resting too far above the D-RING, adjust it by
raising or lowering the two (2) 1/4-2~ IN. NUTS that attaches the LINK CABLE to the PULLEY
BRACKET. When the correct height is obtained SECURELY tightea the two (2) 1/4-28 NUTS together
around the PULLEY BRACKET.
9. To adjust the pre-streteh on the PEC DEC ARMS:
¯
Pull up on the COTTERLESS HITCH PIN.
Swivel the ARM forward or backward.
Let the PIN drop down into one of the two holes in the PEC ARM ADVANCES.
¯
Or let the PIN drop behind the PEC ARM ADVANCES.
NOTE:
IF ASSEMBLING THE LEG PRESS ATTACHMENT NEXT, STOP HERE AND REFER TO
THOSE ASSEMBLY INSTRUCTIONS. IF ONLY ASSEMBLING TIIE PEC DEC ATTACHMENT
TO BASE UNIT, .CONTINUE ON WITH THESE ASSEMBLY INSTRUCTIONS.
I0.
Wrap the SHROUD around the C/’,BLES that route to the D-RING, and assemble the SHROUD to
BOTH SIDES of’the/VIIDDLE U, PRIGHT as shown in (VIEW F-F) on drawing, using the fourteen (I-t)
SHROUD FASTENERS. "
THIS CONCLUDES THE ASSE~,IBLY OF (LEVEL 2), AND
THE ASSEMBLY OF THE PEC DEC ATTACHMENT FOR
THE FACTOR 525 BASE UNIT.