Filter
Top Products
E25 / E55 Elliptical
13
bolt using two wrenches provided. You have to put a wrench on both axle bolts to
tighten firmly.
6. Align the hole in the end of the connecting arm (pivoting rod end) with the hole in
the bracket of the handle bar. The rod end should be on the inside of the handle
bar bracket. Take one of the 1-1/4 X 3/8 bolts and install it through the handle
bar bracket and the rod end. Install a flat washer and Nylon nut on the bolt and
tighten firmly using a wrench on the nut and one on the bolt.
7. Repeat for the right side foot pad/connecting arm.
8. Install the plastic covers over the connection of the rod end and handle bar. The
front inside hole in the plastic uses a self tapping screw and the two rear holes use
the 3/8 machine screws (short). There is a short Phillips screw driver provided for
installing the inside screws.
9. Install the two wheel covers using the four 5/8 machine screws (long).
10. Install the locking pins for the adjustable foot pads into the desired holes (E55).
There are three holes you can use which place the footpad at different angles.
These three positions will work different muscle groups so try them all. If you
experience numb toes after using the E55 for some time, try raising the footpad
angle which should relieve this problem.