Filter
Top Products
11
STEP 5
Attach two Weight Plate Holders (#13) to the holes on the side of
each Left and Right Supports (#6) &(#7). Secure each with a M10
x 20 Hex Bolt (#35) and Washer Dia10 (#39). Attach a Spring Clip
1”(#31) to each weight plate holder.
Insert the two Bar Catches (#15) into upper selected hole on the left
and right Upright Beam. Insert the two Long Bar Catches (#17) into
the bottomhole on the Left and Upright Beam.
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
Assembly