Filter
Top Products
44
43
42
45
Assembly
9
FIGURE 5
Step 1:
Insert the tension cable (45)
into the upright tube (42)
and pull it out from the open-
ing on the upright tube (42).
Connect the sensor wire (40)
on the main frame with the
extension wire (41) on the
upright tube (42). Insert
the upright tube (42) into
the main frame and secure it
with by screws (18) and arc
washers (4).
42
41
45
40
45
18
18
4
18
4
Figure 5
Figure 6
FIGURE 6
Step 1:
Get the tension cable (45) out
of the opening on the handle-
bar post hole, and connect it to
the tension controller (44) as
step 2-4:
Step 2:
Put the cable end (44) into the
spring hook (45).
Step 3:
Pull the knob and force the
short cable (44) into the gap of
the bracket (45).
Step 4:
Insert the tension knob (44)
into the handlebar post (42),
and secure with screw (43)
attached.
Note: Tension is increased by
turning the knob clockwise.
A
44
B
44
45
45