Filter
Top Products
Assembly
Assembly requires the included Allen wrench
and your own Phillips screwdriver.
Do not plug in the power cord until all
assembly steps are completed.
1. With the treadmill deck in the down posi-
tion, leave the unit on the original pack-
ing material to assemble all parts. Refer to
Figure 1.
6
Figure 1: Deck in Down Position
Figure 2: Left and Right Upright Installation
Figure 3: Top Rail Grommet Assembly
2. Install Left Upright to base using four
Allen Bolts M8*15mm (#27) and four Arc
Washers (#41). Hand tighten all hardware
at this time.
Repeat for Right Upright . Refer to Figure 2.
Note: Be careful not to pinch the wire har-
ness.
3. Use the drag line to pull Console Wire
Harness thru the top rail as shown in Figure
3. Place the grommet over the Console Wire
Harness and install the grommet in the top
rail.
Note: Be careful not to pinch the wire har-
ness.
DRAG LINE
GROMMET