Filter
Top Products
6
Getting Started - The CardioZone E-CZ200 Elliptical will require some assembly. Unpack the
box in a clear area. Remove packing material. Do not dispose of packing material until assem-
bly is complete and unit is working properly. Place the unit on a clean level surface for assem-
bly. Make sure there is easy access to an electrical outlet. Before assembling, the unit should
be placed as close as possible to its final location. Locate all hardware bags, Labeled Figure
1 through Figure 9, with the exception of Figure 8. If you are missing any bags, please call
CardioZone at 1-888-340-0482. Tools have been provided to assist with product assembly.
Note: Do not tighten Screws until
you have fully completed Figure 2.
Assembly
Figure 1
Locate bag labeled Figure 1. Locate
console tube. Attach console tube to main
frame. Slide tube down into main frame.
Connect upper console wire to lead wire
assembly. Secure using three M10*80
mm hex head screws extending through
the frame and console tube, three 10x20
washers and three crown nuts, M10*1.5.
Use three M10*120 hex screws to secure
through the front of the console tube and
main frame.
Note: Ensure that all wires are secure
inside console. Be careful not to pinch
wires.
Figure 1
M10*80 HEX SCREW
CROWN NUT, M10*1.5
M10*120 HEX SCREW
UPPER CONSOLE WIRE
LEAD WIRE ASSEMBLY
CONSOLE TUBE
10*20 WASHER