Filter
Top Products
E25 / E55 Elliptical
12
6. Using the two sided wrench tighten the three bolts, and the fourth bolt which is
pre-installed, firmly. These bolts should be tightened as much as you possibly can.
7. Locate the electronic console and the four 1/2 X 1/4 Phillips head screws.
8. There will be three electrical wire connectors at the top opening of the console
mast, two 2 pin (hand pulse sensors), one 10 pin (main wire harness). Connect
these to the mating connectors on the back of the console. The connectors are
keyed so you cannot plug them in the wrong way so do not force them. The two, 2
pin connectors can be plugged into either connector on the back of the console.
9. Storing the excess wire back into the console mast, carefully install the console
onto the mounting plate and secure using the four Phillips head screws.
10.Install the Bottle Holder onto console mast with two M5x12mm Phillips head
screws then place the Bottle in the Bottle Holder.
STEP 3: HANDLE BAR ASSEMBLY
1. Remove the hardware from the hardware pack for step 3. You should have two
5/8 X 3/8 bolts, two large flat washers, two large wave washers and four self
tapping Phillips head screws.
2. Locate and install the 2 large wave washers onto the handle bar axle, one on each
side.
3. Slide the left and right handle bars onto the appropriate side of the axle. There is a
sticker on each handle bar indicating L for left and R for right.
4. Put the large flat washers onto the two 5/8 X 3/8 bolts and install, and tighten, in
the threaded holes in the ends of the axle.
5. Install the plastic covers over the handle bar/axle connections with the six self
tapping Phillips head screws.
STEP 4: FOOT PAD/CONNECTING ARM ASSEMBLY
1. Remove the hardware from the hardware pack for step 4. You should have two
1-1/4 X 3/8 bolts, two flat washers, two Nylon nuts, four 5/8 machine screws
(long), four 3/8 machine screws (short) and two self tapping Phillips head screws.
2. On the pedal arms, in the middle on top, there are two axles already installed in
the bushing housings. Remove, from one side of each axle, the bolt (one should
be loose) and washer. Remove the axle and set aside for the next step.
3. Locate the left foot pad/connecting arm. Holding the rear of the foot pad with your
right hand and the connecting arm, just in front of the foot pad, with your left hand,
place the foot pad over the bushing housing.
4. Holding the axle (removed in step 2) in one hand, and the foot pad in the other,
line up the large hole in the side of the bracket (under the foot pad) with the hole in
the bushing housing and insert the axle all the way until the washer is flush
against the bracket. You may have to wiggle the axle while moving the foot pad
slightly to get the axle to go in.
5. Take the bolt that you removed from the axle in step 2 AND INSTALL THE NEW
ANTI-ROTATION BRACKET, then thread it into the hole in the axle. Tighten the