Filter
Top Products
E25 / E55 Elliptical
11
UNPACKING THE UNIT
1. Using a razor knife (Box Cutter) cut the outside, bottom, edge of box along the dotted
Line. Lift Box over the unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If
damaged parts are found, or parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into steps. Remove the tools
first. Remove the hardware for each step as needed to avoid confusion.
STEP 1: REAR RAIL ASSEMBLY
1. Remove the hardware from the hardware pack for step 1. You should have four
3-3/4 X 3/8 bolts, four curved washers, two 1/4 X 3/8 bolts, two flat washers
and six 3/4 X 1/8 Phillips head screws.
2. Put the two flat washers on the 2-1/4 bolts and hand-tighten them, through the top
of the middle stabilizer tube, into the rear rail assembly.
3. Put the four curved washers on the 3-3/4 bolts and hand-tighten them through the
front of the middle stabilizer tube, into the rear rail assembly.
4. Using the wrench provided tighten all six bolts securely.
5. Locate the four plastic covers for the rear rail assembly and the one cover for the
front stabilizer and install them using the six 3/4 X 1/4 screws and the Phillips
head screw driver provided.
STEP 2: CONSOLE MAST ASSEMBLY
1. Remove the hardware from the hardware pack for step 2. You should have one
2-3/4 X 3/8 bolt, one lock washer, two 1 X 3/8 bolts, two curved washers and
four 1/2 X 1/4 Phillips head screws.
2. Locate the console mast and console mast cover and slide the cover onto the
mast as far as it will go. Make sure the cover is facing the correct way.
3. At the top opening of the main body of the elliptical is a wire harness. Unravel and
straighten out the wire harness and feed it into the bottom of the console mast
tube and out of the top opening.
4. Install the console mast into the receiving bracket in the top of the main body.
NOTE: there is one bolt already installed in the receiving bracket that will engage
with the slot at the bottom of the console mast. This needs to be tightened at the
end along with the three other console mast bolts.
5. Put the flat washer onto the 2 3/4 bolt and the two curved washers onto the two
bolts. Install, and hand tighten, the 2 3/4 bolt through the left side of the
receiving tube into the console mast. NOTE: There is a wire running through the
tube. Be careful not to damage or pinch this wire during this procedure. Damage
to the electronic console could result. Install, and hand tighten, the two 1 bolts
through the front of the receiving tube into the console mast.
Assembly Instructions (E55)