Filter
Top Products
STEP 2 (See Diagram 2)
A.) Attach the Seat Support Bar (#14) to the holes in between the two Seat Brackets
(#13). Slide the Seat Brackets onto the pivot on the Main Seat Support (#4).
B.) Place the Seat (#25) onto the Seat Brackets. Secure it with four M6 x 1 3/8” Hex
Bolts (#39) and ∅ ½” Washers (#50). Insert Seat Support Bar (#14) into the opening
on the Main Seat Support. Insert a 3 ¾” L-shaped Pin (#21) through the holes on
Main Seat Support and Seat Support Bar. Secure it with a Small Spring Clip (#28) to
obtain desired incline of the Seat.
C.) Attach the Backrest Incline Bar (#9) to the holes in between the two Backrest
Supports (#8). Slide the Supports onto the rear pivot on the Main Seat Support (#4).
D.) Place the Backrest Board (#24) onto the Backrest Supports. Secure it with four M6 x
1 3/8” Hex Bolts (#39) and ∅ ½” Washers (#50). Insert a 5 1/8” L-shaped Pin (#20)
through the holes on the Backrest Incline Bar and Main Seat Support to lock the
Backrest Board in a vertical position. Remove the Pin to place the Backrest Board on
the Backrest Adjustment Bar. NOTE: The Incline Support is not designed to sustain
any weight. The only purpose is to get the Backrest Board out of user’s way when
using the Uprights for squat exercise. For any other Weight Lifting exercise, remove
the Pin.
5