Filter
Top Products
STEP 8 (See Diagram 8)
A.) Attach one end of the Leg Developer Cable (#22) to the bottom of Leg Developer
(#1). Secure it with one M10 x 1” Allen Bolt (#41), two ∅ ¾” Washers (#53), and
one M10 Aircraft Nut (#50). Do not over tighten the bolt. The cable ring needs
to be able to swivel on the bolt.
B.) Draw the Cable through the open slot to an open bracket on the Front Stabilizer
(#2). Attach a Large Pulley (#28) to the bracket. Secure it with one M10 x 1 ¾”
Allen Bolt (#42), two ∅ ¾” Washers (#53), and one M10 Aircraft Nut (#50).
C.) Pull the Cable towards the back of the machine. Connect the Cable to the Black,
Red, and Blue Cables with a C-clip (#58) and a Triangle Bracket (#16). Note:
Disconnect the Leg Developer Cable to the Triangle Bracket when folding the
machine up.
DIAGRAM 8
12