Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#6) to the Leg Developer Holder (#4). Secure it with one M10 x 2
7/8” Allen Bolt (#44), two Ø ¾” Washers (#49), and one M10 Aircraft Nut (#48).
B.) Insert two Foam Roll Tubes (#16) halfway through the holes on the Leg Developer (#6). Push
four Foam Rolls (#27) onto the Tubes from both sides.
C.) Attach a Spring Clip (#37) onto the weight post on the Leg Developer.
D.) Slide the Sliding Weight Post (#11) onto the Lat Bar Frame (#7). Insert the Lat Bar Frame into
the opening on the Leg Developer Holder.
E.) Thread a Lock Knob (#38) into the hole on the back of Leg Developer Holder to secure the
Lat Bar Frame. Attach a Spring Clip (#37) onto the weight post on the Sliding Weight Post.
DIAGRAM 3
8