Impex PL 200 Home Gym User Manual


 
COMPUTER
DETAIL OF OPERATION:
SET CLOCK:
Once the batteries are installed, the Hour digit starts flashing. Press UP or DOWN
button to set the hour and then press ENTER. After the Hour is set, the Minute digit
starts flashing. Press UP or DOWN button to set the minute then press ENTER.
Note: If you made a mistake or would like to re-set the clock, remove the batteries then
start over.
AUTO START / STOP
When exercise starts, the monitor will automatically turn on and display the progress.
When exercise stops, the monitor will automatically turn off (after 4 minutes) to save
energy. During the off mode, the Clock and Temperature will display.
DISPLAY:
Temperature Display room temperature when the unit is not in use.
Speed Display the current speed in Mile per Hour.
Speed Zone Display the progress of speed.
Distance Display the distance traveled in Miles.
Time Display the elapsed time.
Calories Display the calorie consumption.
REPLACE BATTERY:
1. Remove the battery cover on the back of the computer.
2. Replace two 1.5V (AA) batteries.
3. Make sure the batteries are installed correctly and the polarities are correct.
4. If the display is not clear or only partial segments appeared, remove the batteries
and wait for 15 seconds before re-install them.
5. The battery life is approx. 3 months under normal usage.
6. When the batteries are removed, all functional values will reset to zero.
12