Filter
Top Products
Step 5
• Attach the Right Seat Handle
(#6) and Left Seat Handle
(#7) to the Seat Support (#5).
Align the holes and secure
them with two M6 x 2 3/8”
Allen Hollow Socket Bolts
(#22) and ∅ 5/8” Washers
(#24) on one side, two M6 x ½”
Allen Bolts (#26) and two ∅
5/8” Washers (#24) on the
opposite side.
Step 6
• Slide the Plastic Sleeve (#16)
onto Front Vertical Post (#12).
Insert Front Vertical Post
(#12) into Front Bike Frame
(#1). Secure them with three
M8 x ½” Allen Bolts (#23) and
∅ 5/8” Washers (#24).
• Connect the sensor wire from
Front Vertical Post to the
sensor wire from Front Bike
Frame (#1).
• To connect the tension wires,
first turn the dial knob on the
top of the Vertical Post
counterclockwise all the way
to the end. Then slide the
cable wire in between the
opening on the lower bracket
and pull up. At last pull the
black housing on the cable
upward and slide it in between
and over the big bracket.
• Slide down the Plastic Sleeve
(#16) to cover up the opening.
6