Filter
Top Products
STEP 8 (See Diagram 8 & Cable Loop Diagram)
A.) Attach a Chain (#51) to the Left Vertical Beam (#4). Secure it with one M10 x 1 3/8”
Allen Bolt (#83), two ∅ 3/4” Washers (#93), and one M10 Aircraft Nut (#90). Attach one
end of the 136” Butterfly Support Cable (#31) to the Chain using a C-clip (#63). NOTE:
After complete installing all the cables, check the tightness of the cable loop system. If
the cable is too loose, shorten the chain.
B.) Draw the Cable to the Angled Double Pulley Bracket (#45) previously installed.
C.) Attach a Pulley to the Bracket. Secure it with one M10 x 2” Allen Bolt (#81), two ∅ ¾”
Washers (#93), and one M10 Aircraft Nut (#90).
D.) Pull the Cable around the Pulley then downward. Repeat Step C above to install a
Pulley to a Single Floating Pulley Bracket (#43). Let the Bracket hanging for now. Draw
the Cable underneath the Pulley then upward through the Left Upper Frame (#11) to
the open Bracket on the top.
E.) Attach a U-shaped Bracket (#49) to the Bracket. Repeat Step C above to install a
Pulley. Draw the Cable over the Pulley then pull the Cable downward to the Selector
Rod (#24). Thread the tip bolt of the Cable into the Selector Rod.
16