Filter
Top Products
STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Attach the 130” Lower Cable (#30) to the opening on the bottom of the Leg
Developer (#10).
B.) Attach a Pulley (#41) to the opening. Secure it with one M10 x 2 ½” Allen Bolt
(#68), two ∅ 7/8” Pulley Bushings (#39), and one M10 Aircraft Nut (#76).
C.) Draw the Cable underneath the Pulley towards the back of the machine to the
open bracket on the back of the Vertical Frame (#3).
D.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#66),
two Ø ¾” Washers (#74), and one M10 Aircraft Nut (#76).
E.) Pull the Cable upward to the Angled Double Floating Pulley Brackets (#13)
previously installed in Step 6. Repeat Step D to install another Pulley.
F.) Draw the Cable around the Pulley then pull downward to the open bracket on the
Main Base Frame (#1). Repeat Step D to install another Pulley.
G.) Draw the Cable around the Pulley then pull upward to the Double Floating Pulley
Bracket (#24) previously installed in Step-5. Repeat Step D to install a Pulley.
H.) After completion of the Lower Cable installation, check the tension of the whole
Cable system. Move the Pulley position on Double Floating Pulley Bracket to
adjust the tension of the Cable Loop System. If the Cables are too tight, move
down the Pulley. If the Cables are too loose, move up the Pulley.
I.) Draw the Cable around the Pulley then pull downward to the bracket on Vertical
Frame. Secure the end of Cable to the bracket with a M10 x 1” Allen Bolt (#65),
two ∅ ¾” Washers (#74) and one M10 Aircraft Nut (#76).
J.) Attach the 15-link Chain (#33) to the end of the Cable by using a C-clip (#35).
Attach the Arm Curl Handle (#18) to the Chain by using another C-clip. Replace
Arm Curl Handle with the Ankle Strap (#58) for various Leg exercises. Adjust the
length of Chain to obtain the desired exercise. Remove the Arm Curl Handle and
Ankle Strap when using the Leg Developer.
18