Filter
Top Products
STEP 6 (See Diagram 6 & Cable Loop Diagram)
A.) Attach one end of the 119” Butterfly Cable (#31) to the hook on the Left Butterfly (#7). Draw
the Cable towards the left open Swivel Pulley Bracket (#12).
B.) Attach a Pulley (#43) to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#66), two ∅ ¾”
Washers (#74), and one M10 Aircraft Nut (#76).
C.) Draw the Cable over the Pulley then pull downward. Attach the Cable to an Angled Double
Floating Pulley Bracket (#13). Install a Pulley as described in Step B. Let the Bracket hanging
for now.
D.) Draw the Cable around the Pulley and pull upward to the right open Swivel Pulley Bracket.
Install another Pulley as described in Step B above.
E.) Draw the Cable over the Pulley and attach the end to the open hook on the Right Butterfly
(#8).
F.) Slide a Ø 1 7/8” Butterfly Foam Roll (#37) onto the Left Butterfly. Attach a Front Press Handle
(#11) to the end of the tube and sure it with a M10 x 2 ¾” Allen Bolt (#69) and ∅ ¾” Washer
(#74). Repeat the same procedure to install the other side.
17