Filter
Top Products
STEP 2 (See Diagram 2)
A.) Slide 9 Weight Plates (#29) onto the Guide Rods (#5). Make sure the deep groove on the
Weight Plates all face the back of the machine and downward. Align the holes on the Weight
Plates. Insert a Selector Rod (#14) through the center hole. Use a Weight Selector Pin (#36)
to select the number of Weight Plates to exercise. Note: Each Weight Plate weights
approximately 10 lbs. Please refer to the Weight Resistance Chart in page 23.
B.) Slide the Selector Stem (#28) onto the Guide Rods.
C.) Attach the holes on the Upper Frame (#4) onto the Guide Rods. Place the Upper Frame
onto the Vertical Frame (#3).
D.) Secure the Upper Frame to the Guide Rods with two M10 x 1” Allen Bolts (#65) and Ø ¾”
Washers (#74).
E.) Secure the Upper Frame to the Vertical Frame with two M10 x 2 3/8” Carriage Bolts (#61),
one 5 1/8” Curved Bracket (#22), two ∅ ¾” Washers (#74), and two M10 Aircraft Nuts (#76).
F.) Securely tighten all Nuts and Bolts installed in Step-1 and Step-2.
9