Filter
Top Products
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#33) to the open bracket on the Main Frame (#27). Secure it
with one M10 x 3 1/8” Allen Bolt (#76), two Ø ¾” Washers (#69), and one M10 Aircraft
Nut (#72). Do not over tighten the bolt and nut, make sure Leg Developer is able to
swivel.
B.) Insert the U-shaped Pin (#39) into the open tube on the Main Frame (#27). Secure it
with one M6 x ½” Philips Screw (#43), Ø ½” Washer (#41), and Spring (#42). Pull and
turn to lock the Leg Developer in position while using the bench at declined position.
C.) Insert three Foam Tubes (#38) halfway through the holes on the Main Frame and Leg
Developer. Push six Foam Rolls (#60) onto the Tubes from both ends. Plug six Foam
Roll End Caps (#56) into the ends.
D.) Slide an Olympic Sleeve (#44) onto the weight post on the Leg Developer.
E.) Attach the Curl Bar Holder (#34) to the Leg Developer and lock it with a L-shaped Pin
(#40).
DIAGRAM 3
8