Filter
Top Products
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended two or more people assembling
this machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do NOT tighten the nuts and bolts until instructed to do so.
B.) Slide two Ø2 ½” Round Rubber Bumpers (#43) onto the Guide Rods (#7). Insert
the two Guide Rods into the holes on the Rear Stabilizer (#8). Secure each Guide
Rod with one M10 x 1” Allen Bolt (#72) and ∅ ¾” Washer (#79) from the bottom.
C.) Attach the rear of Main Base Frame (#1) to the Rear Stabilizer. Secure them with
two M12 x 4” All Bolts (#69), one 4” x 1 ½” Bracket (#20) and two Ø 1” Washers
(#81). Do not tighten the nuts and bolts yet.
D.) Attach the Front Base Frame (#19) to the Main Base Frame. Secure them with two
M10 x 2 3/8” Carriage Bolts (#78), Ø ¾” Washers (#79), and M10 Aircraft Nuts
(#82).
E.) Place the Vertical Frame (#2) onto the Main Base Frame. Secure them with two
M10 x 2 3/8” Carriage Bolts (#78), one Pulley Bracket (#18), two Ø ¾” Washers
(#79), and two M10 Aircraft Nuts (#82).
7