Filter
Top Products
STEP 3 (See Diagram 3)
A.) Place the Seat (#55) onto the Seat Support (#10). Secure it with two M8 x 1 5/8” Allen Bolts
(#67) and Ø 5/8” Washers (#80).
B.) Insert the Seat Support into the opening on the Main Base Frame (#1). Use a Lock Knob
(#53) to secure the Seat Support at desired height.
C.) Attach two ∅1” x ½” Bushings (#34) to the Leg Developer (#9). Attach the Leg Developer to
the bracket on the Main Base Frame. Secure it with one M12 x 3 1/8” Allen Bolt (#71), two Ø
1” Washers (#81), and one M12 Aircraft Nut (#84). Do not over tighten the Nut and Bolt.
Make sure the Leg Developer is able to swivel on the Bolt.
D.) Insert the Foam Tube (#25) halfway through the hole on the Leg Developer (#9). Push two
Foam Rolls (#48) onto the Tubes from both ends. Cover each end with a Foam Roll End
Cap (#54).
E.) Securely tighten all Nuts and Bolts previously installed.
DIAGRAM 3
10