Filter
Top Products
STEP 8 (See Diagram 8 & Butterfly Cable Loop Diagram)
A.) Clip one end of the 98” Butterfly Cable (#34) to the open slot on the Right Butterfly (#10).
B.) Draw the Cable to the open bracket on the right side of the Vertical Frame (#4). Attach a
Small Pulley (#73) to the bracket
C.) Secure it with one M10 x 1 ¾” Allen Bolt (#83), two Ø ¾” Washers (#92), and one M10
Aircraft Nut (#91).
D.) Draw the Cable around the Small Pulley to the right open bracket on the Rear Base
Frame (#14). Repeat Procedure C above to install a Pulley.
E.) Draw the Cable underneath the Pulley then upward to the Angled Double Floating Pulley
Bracket (#27) previously installed in Step-7. Repeat Procedure C above to install a
Pulley.
F.) Draw the Cable around the Pulley then downward to the left open bracket on the Rear
Base Frame. Repeat Procedure C above to install a Pulley.
G.) Draw the Cable underneath the Pulley to the left open bracket on the Vertical Frame.
Install a Small Pulley to the bracket.
H.) Draw the Cable around the Small Pulley then attach the end the Cable to the open slot
on the Left Butterfly.
I.) Attach the Butterfly Base Cover (#21) to the Butterfly Base (#14) to cover the left and
right pivot on the Butterfly Base. Secure the Cover to the Pivots with two M10 x ¾” Allen
Bolts and Ø ¾” Washers (#92).
J.) Align the holes and secure the Cover to the Butterfly Base with two M10 x 3 3/8” Allen
Bolts (#81), four Ø ¾” Washers (#92), and twoM10 Aircraft Nut (#91).
21