Filter
Top Products
STEP 11 (See Cable Loop Diagram & Diagram 11)
A.) Attach the 239” Front Press Cable (#36) to the lower opening on the Leg Developer (#19).
Attach a Pulley (#56) to the opening. Secure it with one M10 x 2 3/8” Allen Bolt (#83), two
Pulley Bushings (#55), and one M10 Aircraft Nut (#96).
B.) Draw the Cable underneath the Pulley to the opening on the bottom of Right Seat Support
(#7). Attach a Pulley to the opening and secure it with one M10 x 1 ¾” Allen Bolt (#82),
two Ø ¾” Washers (#99), and one M10 Aircraft Nut (#96).
C.) Draw the Cable underneath the Pulley then through the bottom opening on the Right
Vertical Beam (#3) to the second open bracket on the Right Base Frame (#1).
D.) Attach a Pulley to the second open bracket. Secure it with one M10 x 1 ¾” Allen Bolt
(#82), two ∅ ¾” Washers (#99), and one M10 Aircraft Nut (#96).
E.) Draw the Cable around the Pulley then upward to the Flat Double Floating Pulley Bracket
(#25) previously installed in Step-9. Install a Pulley to the Bracket on the selected hole.
Note: After completing the entire cable installations, come back to this step and check the
tightness of the cable loop system. If the cables are too loose, move up the pulley on the
bracket. If the cables are too tight, move down the pulley on the bracket.
F.) Draw the Cable around the Pulley then down to the first open bracket on the Right Base
Frame (#1). Install a Pulley with a U-shaped Pulley Bracket (#51).
G.) Draw the Cable around the Pulley then upward to the Angled Double Floating Pulley
Bracket (#24) previously installed in Step-10. Install a Pulley to the selected hole on the
Bracket. Adjust the tension of the cables by changing the Pulley position on the Bracket.
H.) Draw the Cable around the Pulley then down to the open bracket on the back of Right
Vertical Beam (#3). Install a Pulley with a 2 7/8” L-shaped Pulley Bracket (#50).
I.) Draw the Cable through the opening on the Right Vertical Beam to the open bracket on
the back of the Front Press Base (#10). Install a Pulley.
J.) Draw the Cable around the Pulley then back to the lower opening on the Right Vertical
Beam. Install a Pulley to the opening with one M10 x 2 3/8” Allen Bolt (#83), two Pulley
Bushings (#55), and one M10 Aircraft Nut (#96).
K.) Draw the Cable back to the opening on the Front Press Base. Install a Pulley to the
opening with one M10 x 8 ¼” Allen Bolt (#87), two Ø ¾” Washers (#99), and one M10
Aircraft Nut (#96).
L.) Draw the Cable back to the open bracket welded on the lower Right Vertical Beam.
Secure the end of the Cable to the bracket with one M10 x 1” Allen Bolt (#81), two Ø ¾”
Washers (#99), and one M10 Aircraft Nut (#96).
18