Filter
Top Products
8
28
18
6. Hold the Console Base (26) near the right Handrail (18).
Attach the end of the ground wire on the Console Base
to the indicated small hole in the Handrail with a Silver
Ground Screw (27).
Connect the Wire Harness (28) to wire harness on the
Console Base (26). Make sure to connect the connec-
tors properly (see the inset drawing). The connectors
should slide together easily and snap into place. If
the connectors do not slide together easily and snap into
place, turn one connector and try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
27
26
Ground
Wire
22
7. Set the console assembly on the Handrails (18); insert
the excess wiring down into the right Handrail. Attach the
console assembly with four 3/4” Screws (2), two Console
Bolts (22), and two 1/4” Star Washers (21) as shown.
Make sure that no wires are pinched. Start all four
Screws and both Console Bolts before tightening
any of them.
2
22
21
21
2
18
18
6
7
5
. Identify the right Handrail (18) (the Latch Housing [30] is
attached to the left Handrail). Next, identify the Right
Handrail Endcap (92), which has an “R” near the two
screw holes. Slide the Right Handrail Endcap onto the
r
ight Handrail. Next, hold the right Handrail near the
Right Upright (36), and insert the Wire Harness (28)
through an Upright Cap (90), into the hole in the bottom
of the right Handrail, and out of the indicated hole in the
t
op. Then, remove the tie from the Wire Harness.
Insert two Handrail Bolts (20) with two Handrail Star
Washers (19) through the right Handrail (18) and the
Upright Cap (90). Set the right Handrail and the Upright
Cap on the Right Upright (36) while sliding the lower end
of the right Handrail onto the bracket on the Right
Upright. Hand tighten the two Handrail Bolts into the
right Handrail and the Right Upright. Next, slide the Right
Handrail Endcap (92) against the Right Upright, and
tighten two Endcap Screws (95) into the Right Handrail
Endcap. Then, tighten the two Handrail Bolts.
Make
sure that the Wire Harness (28) is not pinched.
Attach the other Handrail (18) to the Left Upright (31) as
described above.
36
3
1
28
19
1
8
19
30
92
Screw
Holes
95
95
20
1
8
90
5
28
Console Assembly
2
0