Filter
Top Products
12
21. Lubricate a M10 x 192mm Bolt (66). Attach the
Backrest Tubes (71) to the welded tube on the Bench
Frame (52) with the Bolt, two M10 Washers (37), and
a M10 Nylon Locknut (29). Note: Do not over tight-
en the Nylon Locknut; the Backrest Tubes must
pivot easily.
21
71
29
37
37
52
66
Lubricate
Welded Tube
22. Attach the Backrest (60) to the Backrest Tubes (71)
with four M6 x 52mm Screws (51) and four M6
Washers (74).
22
74
51
60
71
23. See the inset drawing. Press the 20mm x 40mm Inner
Cap (77) into the open end of the Seat Mounting
Bracket (67).
See the inset drawing. Lubricate a M10 x 68.5mm
Bolt (75). Attach the Seat Adjustment Bracket (80) to
the indicated side of the Seat Mounting Bracket (67)
with the Bolt and a M10 Nylon Locknut (29). Note: Do
not over tighten the Nylon Locknut; the Seat
Adjustment Bracket must pivot easily.
Place the Seat Mounting Bracket (67) on the Bench
Frame (52) so that the Seat Adjustment Bracket (80)
fits over the welded pin on the side of the Bench
Frame.
Lubricate a M10 x 72mm Bolt (34). Attach the Seat
Mounting Bracket (67) to the indicated bracket on the
Bench Frame (52) with the Bolt and a M10 Nylon
Locknut (29). Note: Do not over tighten the Nylon
Locknut; the Seat Mounting Bracket must pivot
easily.
23
52
29
80
67
34
Welded
Pin
Lubricate
Lubricate
75
77
80
29
67
24. Turn the Seat (59) as shown. Attach the wide end of
the Seat to the bracket on the Seat Mounting Bracket
(67) with two M6 x 16mm Screws (50).
Tilt the Seat Mounting Bracket (67) upwards and
attach the narrow end of the Seat (59) to the Seat
Mounting Bracket with a M6 x 35mm Screw (78) and
an M6 Washer (74).
24
50
78
74
67
59
Bracket