Filter
Top Products
8
ID# M581704 01/06
2.
IMPORTANT!
ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART
3
2
4
TOP
MIDDLE
BOTTOM
alignment mark
alignment mark
alignment mark
Align poles using alignment marks. First, pound top and
middle poles together by bouncing them on a scrap piece of
wood on the ground as shown in FIG A. until they no longer
move toward pole identification stickers. THEN add bottom
pole section and pound together in the same way.
FIG A.
scrap wood
(Not Supplied)
middle pole
IDENTIFICATION
STICKER
middle pole
IDENTIFICATION
STICKER
3-1/2”
1-1/4"
THE IDENTIFICATION STICKER IS
LOCATED 3-3/4" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 2-1/2"
MINIMUM OVERLAP, LEAVING 1-1/4"
BETWEEN THE OVERLAPPING POLE
AND THE IDENTIFICATION STICKER.
CAUTION!