Filter
Top Products
CONSOLE
GRIP PULSE HANDLEBARS
RUNNING BELT
TRANSPORT WHEEL
SIDE RAIL
LEVELERS
MOTOR
COVER
WATER BOTTLE
HOLDER
UPRIGHT
SUPPORT
TOUCH PAD
ROLLER
END CAP
KNOW YOUR TREADMILL
Horizon Fitness treadmills are designed to be reliable and easy to use. However, if you experience
a problem, please reference the troubleshooting guide listed below.
PROBLEM: The console does not light up.
SOLUTION: Verify that the power cord is plugged in properly to the outlet, and that the treadmill
switch is turned on.
PROBLEM: The treadmill circuit breaker trips during a workout.
SOLUTION: Verify that the treadmill is plugged into a dedicated 20amp circuit.
NOTE: no extension cord.
PROBLEM: The treadmill shuts off when elevating
SOLUTION: Verify that there is enough slack in the power cord to reach to the wall outlet during
elevation.
PROBLEM: The running belt does not stay centered during a workout.
SOLUTION: Verify that the treadmill is on a level surface. Verify that the belt is properly tight-
ened (refer to Centering The Belt.)
PROBLEM: The treadmill makes a clicking noise towards the front of the machine while walking or
running on it.
SOLUTION: For optimum use, the treadmill needs to be level. Refer to the section on leveling
your treadmill.
Check your exercise environment for sources of interference such as fluorescent lights, computers, or
appliances containing large motors. These items may cause erratic heart rate readouts.
You may experience an erratic readout under the following conditions:
• Gripping the heart rate handlebars too tight. Try to maintain
moderate pressure while holding onto the heart rate handlebars.
TROUBLESHOOTING YOUR TREADMILL
HEART RATE TROUBLESHOOTING
28 ELITE SERIES13 ELITE 3.0T, 4.0T & 5.0T
HAND RAILS
GRIP PULSE HANDLEBARS
ROLLER
END CAP
RUNNING BELT
TRANSPORT WHEEL
LEVELERS
SIDE RAIL
MOTOR COVER
UPRIGHT
SUPPORT
WATER BOTTLE
HOLDER
CONSOLE
TOUCH PAD
ELITE 3.0T
ELITE 4.0T & 5.0T
elite treadmill owner’s guidev1.1.qxd 10/13/2003 11:40 AM Page 14