Filter
Top Products
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
AS SE MB LY ST E P 5
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (K)
CONSOLE
HANDLEBAR BRACKET
RIGHT SIDE:
CONNECT CONSOLE
CABLES, PULSE CABLES
AND POWER CABLES
LEFT SIDE:
CONNECT PULSE
CABLES ONLY
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 4
BOLT (K)
20 mm
Qty: 4
HARDWARE BAG 5 CONTENTS:
Open HARDWARE BAG 5.
Place CONSOLE onto HANDLEBAR
BRACKETS as shown.
NOTE: Do not pinch CONSOLE CABLE
when placing the console onto the
handlebar brackets.
Insert 2 BOLTS (K), 2 SPRING
WASHERS (C) and 2 FLAT WASHERS
(B) through the bottom of the
HANDLEBAR BRACKET to secure the
console to the HANDLEBAR BRACKET.
Repeat on other side.
Reach inside the right underside of
the console to pull out the CONSOLE
CABLE, PULSE CABLE and POWER
CABLE. Attach to the matching cables
that are hanging out of the cable hole
in the handlebar.
Repeat on left side to attach PULSE
CABLE.
Thread attached cables back through
the cable holes when finished.
A
B
C
D
E
F
G
NOTE: Do not completely tighten
any screws or bolts until step 6 is
complete!
AS SE MB LY ST E P 4
CONSOLE
CUP HOLDER
SCREW (P)
SCREWS (O)
Open HARDWARE BAG 4.
Attache CUP HOLDERS to CONSOLE by inserting 4 SCREWS (O) and 2 SCREWS (P).
A
B
SCREW (O)
15 mm
Qty: 4
SCREW (P)
30 mm
Qty: 2
HARDWARE BAG 4 CONTENTS:
NOTE: Assembly of cup holders may be easier if console is flipped upside down before inserting
screws. Be careful not to overtighten screws.
T901_Rev.2.0.indd 12-13 9/10/08 11:15:40 AM