Filter
Top Products
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 4
SUPPORT BAR
BOLTS (I)
CONSOLE MAST
BOLT (I)
15 mm
Qty: 4
HARDWARE BAG 4 CONTENTS :
Open HARDWARE BAG 4.
Align SUPPORT BAR with holes in CONSOLE MASTS.
Insert BOLTS (I) into all 4 holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
Tighten support bar bolts completely.
A
B
C
D
A S S E M B LY S T E P 3
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
CONSOLE CABLES
RIGHT CONSOLE MAST
BOLTS (G)
SPRING WASHERS (H)
FLAT WASHERS (B)
CONSOLE
FLAT WASHER (B)
20 mm
Qty: 4
SPRING WASHER (H)
15 mm
Qty: 4
BOLT (G)
20 mm
Qty: 4
HARDWARE BAG 3 CONTENTS :
Open HARDWARE BAG 3.
With running deck in lowered position, place CONSOLE on upright masts. Align the
brackets that are underneath the console with the top holes of the upright masts.
To assemble the LEFT CONSOLE MAST to the CONSOLE, insert 1 BOLT (G), 1 SPRING
WASHER (H) and 1 FLAT WASHER (B) into the 2 holes in the LEFT CONSOLE MAST and
lightly tighten.
Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLE. Carefully tuck wires
in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.
Repeat STEP C above to attach the RIGHT CONSOLE MAST to the CONSOLE.
Tighten console bolts completely.
A
B
C
D
E
F
* NOTE: Be
careful not to
pinch any
wires while
attaching the
console.
T700-T800_Treadmill_Rev.1.4.indd10-11 10-11 4/23/07 10:09:22 AM