Filter
Top Products
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Open HARDWARE BAG 7.
Remove NYLON NUT, FLAT WASHER, THREADED SCREW and BALL from end of CABLE C.
Route CABLE C through the pulley system in the RADIAL ARM ASSEMBLY as shown in
diagram.
NOTE: After threading through one arm of RADIAL ARM ASSEMBLY thread CABLE C up
through SINGLE FLOATING PULLEY BRACKET before bringing to back through other arm.
After CABLE C routing is complete replace nylon nut, threaded screw and ball on end of
cable.
Hook HANDLES on to cable using the 2 HOOKS.
A
B
C
D
E
A S S E M B LY S T E P 8
CABLE C
Qty: 1
HARDWARE BAG 7 CONTENTS :
BALL
NYLON NUT
FLAT WASHER
HANDLE
HANDLE
HOOK
CLEVIS
FLAT WASHER (B)
SCREW (E)
SINGLE FLOATING
PULLEY BRACKET
CABLE C
Open HARDWARE BAG 8.
Remove nylon nut, threaded screw and ball from end of CABLE D.
Route CABLE D through the pulley system in the UPPER PULLEY BRACKET ASSEMBLY as
shown in diagram.
After CABLE D routing is complete replace nylon nut, threaded screw and ball on end of
cable.
A
B
C
D
A S S E M B LY S T E P 9
CABLE D
Qty: 1
HARDWARE BAG 8 CONTENTS :
BALL
NYLON NUT
FLAT WASHER
HOOK
CLEVIS
FLAT WASHER (B)
CABLE (D)
LAT BAR
SCREW (E)
SXS_5.7_rev.1.1.indd 14-15 8/30/07 11:13:01 AM