Filter
Top Products
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Open HARDWARE BAG 3.
Attach LEG EXTENSION/CURL DOWN TUBE to SEAT ASSEMBLY using 1 BOLT (G), 2 FLAT
WASHERS (B) and 1 NYLON NUT (C).
NOTE: Position the LEG EXTENSION/CURL DOWN TUBE so the cable attachment is facing
the gym.
Insert SEAT SET SAFETY PIN.
A
B
C
A S S E M B LY S T E P 4
NYLON NUT (C)
Qty: 1
FLAT WASHER (B)
Qty: 2
BOLT (G)
Qty: 1
HARDWARE BAG 3 CONTENTS :
SEAT SET SAFETY PIN
FLAT WASHER (B)
NYLON NUT (C)
CENTER SUPPORT FRAME
SEAT WELDMENT SET
BOLT (G)
FLAT WASHER (B)
LEG EXTENSION/
CURL DOWN TUBE
CABLE ATTACHMENT
Open HARDWARE BAG 4.
Attach SEAT BACK PAD to CENTER SUPPORT FRAME using 2 SCREWS (H), 2 FLAT
WASHERS (B).
Attach SEAT BOTTOM PAD to SEAT WELDMENT using 2 BOLTS (D), 4 FLAT WASHERS (B)
and 2 NYLON NUTS (C).
Install assembled seat into gym.
Install LEG PADS to LEG EXTENSION/CURL DOWN TUBE as shown in diagram.
A
B
C
D
E
A S S E M B LY S T E P 5
FLAT WASHER (B)
Qty: 6
BOLT (H)
Qty: 2
BOLT (L)
Qty: 2
NYLON NUT (C)
Qty: 2
HARDWARE BAG 4 CONTENTS :
END COVER
FOAM ROLLER
LEG EXTENSION/
CURL DOWN TUBE
SEAT BOTTOM PAD
CENTER SUPPORT FRAME
SEAT BACK PAD
FLAT WASHER (B)
SCREW (H)
FLAT WASHER (B)
NYLON NUT (C)
ADJUSTMENT BAR
BOLT (L)
SXS_5.7_rev.1.1.indd 10-11 8/30/07 11:12:48 AM