Filter
Top Products
Assembly
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recom-
mended that you place a protective covering on your floor. Note: It is recommended that you apply
grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your recumbent
bike on a level flat surface. It is recommended that you place a protective covering on your floor.
Parts (see illustration on previous page)
• 1 Rear Foot Tube
• 1 Handlebar Set
• 1 Seat Rail
• 1 Seat Back
• 1 Seat Frame
• 1 Console Mast
• 1 Console Mast Boot
• 2 Mobile Wheels
• 1 Console
• 2 Pedals
• 2 Wheel Sleeves
• 1 Power Supply
• 1 Seat Rail Boot
(contents listed below)
Tools (included)
• 5mm Allen Wrench/
Phillips Screw Driver
• 13/15mm Flat Wrench
CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @ 1-800-244-4192
OR VISIT www.horizonfitness.com
7