Horizon Fitness 3.1E Home Gym User Manual


 
8
Assembly
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recom-
mended that you place a protective covering on your floor. Note: It is recommended that you apply
grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your elliptical
trainer on a level flat surface. It is recommended that you place a protective covering on your floor.
PARTS (see illustration on previous page)
• 1 Front Foot Tube
• 2 Upper Handlebars
• 2 Lower Handlebars/Link Arms
• 2 Pedal arms
• 2 Foot Pads
• 2 Guide Rails
• 1 Console
• 1 Console Mast
• 1 Console Mast Boot
• 1 Power Supply
• 2 Crank Boots
• 2 Front Upper Handlebar Covers
• 2 Back Upper Handlebar Covers
• 1 Hardware Pack
TOOLS (included)
4mm Allen Wrench
5mm Allen Wrench/Phillips Screw Driver
13/15mm Flat Wrench
17mm Wrench
CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @ 1-800-244-4192
OR VISIT www.horizonfitness.com