Filter
Top Products
BEFORE
YOU BEGIN
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
RIGHT LOWER LINK ARM
U-BRACKET
SPLIT TEFLON WASHERS (I)
FLAT WASHER (J)
BOLT (K)
CONNECTING TUBE
SPACER (H)
RIGHT PEDAL ARM
Open HARDWARE BAG FOR STEP 6.
Align the U-BRACKET on the RIGHT LOWER LINK ARM with the CONNECTING TUBE on the RIGHT
PEDAL ARM.
Slide the SPACER (H) through the U-BRACKET and the CONNECTING TUBE so that it can no longer
rotate.
Insert 2 SPLIT TEFLON WASHERS (I) between the CONNECTING TUBE and the U-BRACKET.
Secure the joint with a FLAT WASHER (J) and BOLT (K).
Repeat on the other side.
A
B
C
D
E
F
SPLIT TEFLON
WASHER (I)
28 mm
Qty: 4
SPACER (H)
72 mm axis
Qty: 2
FLAT WASHER (J)
35 mm
Qty: 2
BOLT (K)
15 mm
Qty: 2
HARDWARE BAG FOR STEP 6 CONTENTS :
A SS E M B LY ST E P 6 A SS E M B LY ST E P 7
PRE-ATTACHED SPACER RINGS AND SPACER
LOWER HANDLEBAR
LOWER LINK ARM
PRE-ATTACHED NUT, FLAT WASHER AND BOLT
LOWER LINK ARM
SPACER
SPACER RINGS
LOWER HANDLEBAR
NOTE: There is no hardware bag for this step
Remove PRE-ATTACHED SPACER, SPACER RINGS, BOLTS, FLAT
WASHERS and NUTS from LOWER LINK ARM.
Slide PRE-ATTACHED SPACER into LOWER LINK ARM.
Place 2 PRE-ATTACHED SPACER RINGS on both sides of
PRE-ATTACHED SPACER. While holding PRE-ATTACHED SPACER
RINGS, slide LOWER LINK ARM into bottom end of
LOWER HANDLEBAR.
Insert 1 PRE-ATTACHED BOLT into LOWER HANDLEBAR and secure
using 1 PRE-ATTACHED WASHER and 1 PRE-ATTACHED NUT.
Repeat on other side.
A
B
C
D
E
Confirm that the
LOWER HANDLEBAR
and the LOWER LINK ARM
are marked R. The left
side is marked L.
E901_Rev.1.7.indd 12-13 9/10/08 11:07:03 AM