Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A SS E M B LY ST E P 4
PRE-ATTACHED WASHERS
LOWER HANDLEBAR
CONSOLE MAST
PRE-ATTACHED
WASHER & BOLT
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
Remove PRE-ATTACHED BOLT & WASHER from CONSOLE MAST.
Slide LOWER HANDLEBAR onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED WASHER & BOLT.
Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR.
Slide UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED SET
SCREWS.
Remove PRE-ATTACHED SCREWS located on the front and back of the HANDLEBARS.
Attach HANDLEBAR COVERS with PRE-ATTACHED SCREWS.
Repeat on other side.
A
B
C
D
E
F
G
After handlebars are assembled they will rotate freely – be cautious. Until
the machine is fully assembled, do not grab the handlebars for support.
WARNING
PRE-ATTACHED
SCREWS
HANDLEBAR COVERS
UPPER
HANDLEBAR
A SS E M B LY ST E P 5
SCREWS (F)
WASHERS (G)
LINK ARM
FOOTPAD
Open HARDWARE BAG FOR STEP 5.
Attach FOOTPAD to LINK ARM using 4 SCREWS (F) and 4 WASHERS (G).
Repeat on other side.
A
B
C
WASHER (G)
18 mm
Qty: 8
SCREW (F)
16 mm
Qty: 8
HARDWARE BAG FOR STEP 5 CONTENTS :
E901_Rev.1.7.indd 10-11 9/10/08 11:06:57 AM