Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY ST E P 3
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLT & WASHERS from PIVOT TUBE.
B) Slide PEDAL ARM onto PIVOT TUBE and attach by re-inserting PRE-ATTACHED BOLT and WASHERS.
C) Repeat on the other side.
D) Attach the PEDAL ARM COVER to the right PEDAL ARM using PRE-ATTACHED SCREW.
E) Repeat on the other side.
PIVOT TUBE
PEDAL ARM
PEDAL ARM COVER
PRE-ATTACHED WAVY WASHER
PRE-ATTACHED WASHER
PRE-ATTACHED BOLT
PRE-ATTACHED SCREW
A S S E M B LY ST E P 4
RIGHT HANDLEBAR
PRE-ATTACHED NUT AND WASHERS
HANDLEBAR COVER
PRE-ATTACHED SCREW
CONSOLE MAST
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED NUT & WASHERS from CONSOLE MAST.
B) Remove PRE-ATTACHED SCREW from RIGHT HANDLEBAR.
C) Slide RIGHT HANDLEBAR onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED NUT & WASHERS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
D) Snap HANDLEBAR COVERS together over the RIGHT HANDLEBAR. Note the position of the snap tabs on the
covers before snapping into position.
E) Attach HANDLEBAR COVERS with PRE-ATTACHED SCREW.
F) Repeat on other side.
E900_E1200_Rev.2.7.indd 10-11 6/16/08 9:45:43 AM