Horizon Fitness E900 Elliptical Trainer User Manual


 
BEFORE
YOU BEGIN
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY ST E P 7
LOWER HANDLEBAR
SPACER RING (O)
SPACER (N)
BOLT (M)
WASHER (P)
NUT (Q)
LOWER LINK ARM
PRE-ATTACHED
HARDWARE
LOWER LINK ARM
SPACER (N)
SPACER RINGS (O)
LOWER
HANDLEBAR
A) Open HARDWARE BAG FOR STEP 7.
B) Slide SPACER (N) into LOWER LINK ARM.
C) Place 2 SPACER RINGS (O) on both sides of SPACER (N). While holding
SPACER RINGS (O), slide LOWER LINK ARM into bottom end of LOWER HANDLEBAR.
D) Insert 1 BOLT (M) into LOWER HANDLEBAR and secure using 1 WASHER (P) and 1 NUT (Q).
E) Repeat on other side.
A S S E M B LY ST E P 8
SCREWS (R)
OUTSIDE ELBOW COVER
INSIDE ELBOW COVER
SCREWS (S)
OUTSIDE ELBOW COVER
INSIDE ELBOW COVER
SCREWS (S)
SCREWS (R)
A) Open HARDWARE BAG FOR STEP 8.
B) Attach the INSIDE and OUTSIDE ELBOW COVERS to the right LOWER LINK ARM using 2 SCREWS (R).
C) Tighten the ELBOW COVERS together at the front using 1 SCREW (S).
D) Repeat on other side.
SCREW (R)
8 mm
Qty: 4
SCREW (S)
10 mm
Qty: 2
HARDWARE BAG FOR STEP 8 CONTENTS :
BOLT (M)
45 mm
Qty: 2
SPACER (N)
Qty: 2
SPACER RING (O)
Qty: 4
WASHER (P)
18 mm
Qty: 2
NUT (Q)
18 mm
Qty: 2
HARDWARE BAG FOR STEP 7 CONTENTS :
E900_E1200_Rev.2.5.indd 14-15 6/22/07 4:14:59 PM