Filter
Top Products
BEFORE
YOU BEGIN
6
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
7
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
TOP CAP
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME
CONSOLE WIRE
FLAT WASHER (C)
SPRING WASHER (B)
BOLT (A)
ARC WASHER (D)
A S S E M B LY ST E P 1
A) Open HARDWARE BAG FOR STEP 1.
B) Slide the CONSOLE MAST BOOT followed by the TOP CAP
over the CONSOLE MAST
.
C)
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D) Attach the sides of the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4
FLAT WASHERS (C).
E) Attach the front of the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (A), 2 SPRING WASHERS (B) and 2
ARC WASHERS (D).
F) Slide CONSOLE MAST BOOT down to seal the console mast hole.
BOLT (A)
15 mm
Qty: 6
SPRING WASHER (B)
Qty: 6
FLAT WASHER (C)
20 mm
Qty: 4
ARC WASHER (D)
17 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
TOOLS INCLUDED PARTS INCLUDED
c 5mm L Wrench
c 5mm T Wrench
c Phillips Screw Driver
c 13/17mm Flat Wrench
c 1 Console
c 1 Console Mast
c 2 Upper Handlebars
c 2 Lower Handlebars
c 2 Lower Link Arms
c 2 Pivoting Foot Pads
c 2 Elbow Covers Sets
c 2 Handlebar Cover Sets
c 2 Mid-Stabilizer Feet
c 2 Guiderail Caps
c 1 Console Mast Boot
c 1 Top Cap
c 2 Pedal Arms
c 2 Pedal Arm Covers
c 2 Roller Wheel Covers
c 6 Hardware Bags
c 1 Power Supply
c 1 Audio Adaptor Cable
SPEAKERS CONSOLE
UPPER HANDLEBAR
LOWER HANDLEBAR
LOWER LINK ARM
FRONT STABILIZER TUBE
FAN
GRIP PULSE
CONSOLE MAST
TOP CAP
PIVOTING FOOT PAD
PEDAL ARM
GUIDERAIL CAPS
HANDLEBAR COVER SET
CONSOLE MAST BOOT
ELBOW COVER SET
CUSTOMSTRIDE
™
ADJUSTMENT KNOB
If you have questions or if there are any missing parts, contact Customer Tech Support.
If any warning decals become worn, damaged, or missing, they should be replaced.
Contact information is located on the back panel of this manual.
MID-STABILIZER FOOT
ROLLER WHEEL COVER
PEDAL ARM COVER
For a complete exploded diagram, visit us at www.horizonfitness.com
TOP CAP
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME
CONSOLE WIRE
FLAT WASHER (C)
SPRING WASHER (B)
BOLT (A)
ARC WASHER (D)
H-series_E5_Rev.1.2.indd 6-7 6/16/08 2:40:06 PM