Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A Slide the HANDLEBAR SLEEVE onto
the bottom of the
HANDLEBAR
EXTENSION.
B Slide the HANDLEBAR EXTENSION
onto the
CONSOLE HANDLEBAR.
C Insert BOLTS (?) into HANDLEBAR
EXTENSION.
D Insert BOLT (?) through bottom
hole of
HANDLEBAR EXTENSION
into CONSOLE MAST.
E Tighten all HANDLEBAR
EXTENSION bolts.
F Slide HANDLEBAR SLEEVE all
the way down on
HANDLEBAR
EXTENSION to cover BOLT (?).
G Repeat on other side.
A Slide the LONG HANDLEBAR
EXTENSION onto the CONSOLE
HANDLEBAR.
B Insert BOLTS (?) into LONG
HANDLEBAR.
C Align the lower part of the LONG
HANDLEBAR with the center of the
CONSOLE MAST
.
D Insert BOLTS (?) through bottom
holes of
LONG HANDLEBAR into
CONSOLE MAST.
E Tighten all LONG HANDLEBAR
bolts.
F Repeat on other side.
A S S E M B LY S T E P 5- B (CST4.5 model)
A S S E M B LY S T E P 5- A (CST3.5 model)
A Slide PLASTIC COVER CAPS over
SUPPORT BARS
.
B Slide SUPPORT BARS into side
MOUNTING BRACKETS and line up
with top MOUNTING BRACKETS
.
C Insert 2 BOLTS (?) into the tops
and 2 BOLTS (?) into the bottoms
of each SUPPORT BAR
.
D Slide PLASTIC COVER CAPS down
to cover BOLTS (?).
E Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'on' position, so that
the switch is lit. You will hear a
beep and the console will light up.
A S S E M B LY S T E P 6
Y O U ’ R E F I N I S H E D !
POWER SWITCH
CIRCUIT BREAKER
CST3.5-4.5 Treadmill Rev0.2.indd 10-11 4/21/05 11:22:41 AM