BEFORE
YOU BEGIN
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 7 (CSE4. 5 O NLY)
A) Open HARDWARE BAG FOR STEP 7.
B) Pull LOWER LINK ARM towards you to acess elbow joint to attach ELBOW COVERS. Once it is in it’s forward
most position, rest the LOWER LINK ARM on the GUIDE RAIL (as shown).
CAUTION:
Be careful to keep the LOWER LINK ARM and LOWER HANDLEBAR aligned with guide rail. Do not
twist them to the left or right while pulling them towards you.
C) Attach INSIDE & OUTSIDE ELBOW COVERS to elbow joint using 2 SCREWS (L) and 1 SCREW (M) (as shown).
D) Repeat on other side.
A S S E M B LY S T E P 8
A ) Open HARDWARE BAG FOR STEP 8.
B) Align LOWER LINK ARM with U BRACKET.
CAUTION:
Be careful to keep the LOWER LINK ARM aligned with guide rail. Do not twist it to the left or right
while positioning it on the U BRACKET.
C) Insert 2 TEFLON WASHERS (E) on left and right sides of FOOT PLATE TUBE before sliding SPACER (F) through
U BRACKET and FOOTPLATE TUBE.
D) Insert FLAT WASHER (C) and BOLT (G) into outside end of FOOTPLATE TUBE to secure LOWER LINK ARM to
PEDAL ARM.
E) Repeat on other side.
HARDWARE BAG FOR STEP 8 CONTENTS :
HARDWARE BAG FOR STEP 7 CONTENTS : CSE4.5 ONLY
CSE4.5 ONLY
CSE3.5-4.5 Elliptical Rev 0.4.indd 14-15 6/3/05 5:42:17 PM