Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 3
A) Open HARDWARE BAG FOR STEP 3.
B) Attach the PERIMETER BARS using 4 BOLTS (E).
C) Attach REAR STABILIZER COVER using 2 SCREWS (F).
D) Attach FRONT STABILIZER COVERS using 2 SCREWS (F) for each side.
HARDWARE BAG FOR STEP 3 CONTENTS :
A S S E M B LY S T E P 4
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLTS & WASHERS.
C) Attach UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
CSE3.5-4.5 Elliptical Rev 0.4.indd 10-11 6/3/05 5:42:08 PM