Filter
Top Products
BEFORE
YOU BEGIN
ASSEMBLY
7
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
BOLT (A)
ARC WASHER (C)
SPRING WASHER (B)
FLAT WASHER (D)
SPRING WASHER (B)
CONSOLE MAST
TOP CAP
CONSOLE WIRES
MAIN FRAME BRACKET
MAIN FRAME
BOLT (A)
A S S E M B LY S T E P 1
A) Open HARDWARE BAG FOR STEP 1.
B) Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the CONSOLE MAST.
C) (For Models: 3.3E and 4.3E only) Slide the MAST BOOT onto and up the CONSOLE MAST.
D) Slide the TOP CAP onto and up the CONSOLE MAST.
E) Attach the CONSOLE MAST to the MAIN FRAME BRACKET using 2 BOLTS (A), 2 SPRING WASHERS (B), and 2 ARC
WASHERS (C) on the front of the console mast. Attach the CONSOLE MAST on the sides using 2 BOLTS (A), 2 SPRING
WASHERS (B), and 2 FLAT WASHERS (D) on each side.
F) Slide the TOP CAP (and boot if applicable) down onto the MAIN FRAME.
BOLT (A)
15 mm
Qty: 6
SPRING
WASHER (B)
15 mm
Qty: 6
FLAT
WASHER (D)
20 mm
Qty: 4
angle view
ARC
WASHER (C)
17 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
2.3E SHOWN
CONSOLE MAST
MAST BOOT
TOP CAP
3.3E and 4.3E ONLY