Filter
Top Products
BEFORE
YOU BEGIN
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
A S S E M B LY S T E P 5 ( C O N T I N U E D )
PRE-ATTACHED
SET SCREWS
UPPER HANDLEBAR
LOWER HANDLEBAR
TAB
NOTCH
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Slide UPPER HANDLEBAR onto LOWER HANDLEBAR and align NOTCH with TAB making sure handlebars are
joined together completely. Secure UPPER HANDLEBAR to LOWER HANDLEBAR using PRE-ATTACHED SET
SCREWS.
B) Repeat on other side.
C) (For 4.3E only) Attach WIRE from UPPER HANDLEBAR to WIRE from CONSOLE MAST.
D) Snap the front and back HANDLEBAR COVERS together onto the UPPER HANDLEBARS. Note the position
ot the snap tabs on the covers before snapping into position. (On 4.3E, tuck wires inside of HANDLEBAR
COVERS, CAREFUL not to pinch any wires).
E) Repeat on other side.
HANDLEBAR COVERS
UPPPER HANDLEBAR
UPPPER HANDLEBAR
UPPPER HANDLEBAR WIRE
CONSOLE WIRE
CONSOLE MAST
FOR 4.3E ONLY